3 and F.3a
Single-Phase, 2-Conductor, Systems
Nominal Voltage the Power Supply
System (Mains)*
Voltages for Table F.14
4000 1.67
20000 5.1.95
8000 35.3 DIN 60664-1/
VDE 0110-1 contain the rated voltages that
have considered for dimensioning the
minimum creepage distances.
*For the relationship rated voltage, see 4.2.5 3. This because the actual voltage ground determined the insulation resistance
and capacitive reactance each conductor ground; thus, low (but acceptable) insulation resistance one con-
ductor can effect ground and raise the other two full conductor-to-conductor voltage ground.5
.
Electrical Tests (continued)
Tests and Testing Procedures per IEC/EN Standards (continued)
Table F.25
9000 30.5 2.3.5 14.com
WAGO Rail-Mount Terminal Block Systems
Technical Information
• Insulation Parameters per IEC/EN 60664-1 (continued)
Creepage Distances,
Rated Voltages,
Material Groups
Criteria for dimensioning creepage distances
are the rated voltages, pollution degrees and
material groups.7
7000 1.
The pollution degrees specified for the clear-
ances, and its quoted allocation locations,
is also applicable for creepage distances.
Tables F.
**These values correspond the values given Table F.5
24
25 25
30 32
42
48
50**
50
60 63
30 32
100** 100
110
120
125
150** 160
200 200
110 200 200 100
220 250
110 220
120 240 250
300** 320
220 440 500 250
600** 630
480 960 1000 500
1000** 1000
1)
Conductor-to-ground insulation level for non-grounded impedance-grounded systems equals that for conduc-
tor-to-conductor, the operating voltage ground any conductor can, practice, approach full conduc-
tor-to-conductor voltage.5 2.62
10000 26.48
6000 1.wago.02
15000 6.5 12.
Altitude
m
Standard
Air Pressure
(in kPa)
Multiplier
for
Clearances
2000 1
3000 1.4
For insulation conductor-to-con-
ductor1)
For insulation conductor-to-ground1)
All systems Three-conductor systems,
center-point grounded
V V
12.29
5000 1.16
www
