. The Ion charging station does not function (no LED display). 3
Max. +50 °C
Number usable phases max. conductor cross-section,
single-wire/fine-wire
10 mm²
Max.
4.32 A
Charging voltage [V] 230/400 V
Charging cable length m
Charging connector Type 2
DC error current protection mA
Operating temperature –25 °C..EN
Mounting instructions for the Ion charging stations
FAQs frequently asked questions
13 FAQs frequently asked questions
1.
2.7 Adjusting the
charging current/DIP switch configuration“ page 23.
3. single-phase operation the Ion charging station possible?
3 Yes, every model the OBO charging station can operated in
single-phase mode. conductor cross-section
with wire-end ferrule
6 mm²
Charging station protection class IP66
Protection class cable with
protective cap
IP54
Protection class cable without
protective cap
IP44
Impact resistance IK08
Communication Modbus RTU protocol via RS-485 interface
Potential-free enabling contact IC/0 closed: Not ready for operation, charging not possible
IC/0 open: Ready for operation, charging possible
Tab. 10: Technical data
.. The charging power the Ion charging station lower than
expected.
14 Technical data
Dimensions [mm] 330 300 127 370 340 136 mm
Mounting type Wall mounting
Charging power, max. With regard the status LED, also
consult Troubleshooting“ page 29. How must the Ion charging station protected electrically?
3 The Ion charging station must fully protected the building
installation.
If this not the case, check whether current limitation was set dur-
ing the installation the charging station See also „6.. Always observe all the local regulations the operation
of electrical devices. What could the reason?
3 Check whether limitation the charging power was set the ve-
hicle (refer the operating instructions the vehicle charged). kW, 3-phase
Charging current [A] 6.
How can work out what wrong?
3 Check the miniature circuit breaker and error current protection
switch the building installation
