1. Reassemble the charging controller and connect the charging
station.1 Performing software update
The software the Ion charging station requires update according to
the valid regulations. Should software update the charging station be
necessary future, then the update can performed the following
manner. Carry out the update from the connected computer.
6. This can done
directly from the Atmel Studio programming environment with
PowerShell programming commands the set-up laptop. Take the chipset out the housing and separate the two.
In this case, the charging controller supplied with power directly from
the programming adapter.
4.
2. this, pull the
edges the rear side outward.
5. Open the rear side the charging controller. Programming can carried out with programming
devices, which are compatible with Atmel processors.
12 Disposing the product
Comply with the local waste disposal regulations. Remove the charging controller from the charging station.OBO Bettermann
Dismantling the product
Inspection and possible exchange def-
ective V10 Compact surge protection device
on the Ion Basic Protect charging station and
Ion Key Protect charging station
Every years after lightning strike
Electrical techni-
cian
Inspection (with Life Control 5096786) and, if
necessary, possible exchange defective
MDP 5/12 surge protection device the Ion
Basic Protect charging station and Ion Key
Protect charging station
Every years after lightning strike
Electrical techni-
cian
*With the Ion Basic Protect and Ion Key Protect charging station variants, the
surge protection installed the charging station must disconnected before
the inspection.
11 Dismantling the product
Dismantling the charging station takes place the reverse order to
mounting. Connect the programming adapter the CPU board.
The update takes place using Atmel device programmer and pro-
gramming adapter.
10.
– Product: electrical waste
– Packaging: household waste
.
3
