3.
0 Test and assign the coil position the end switches 'Higher' and 'Lower'
0 Operating time for the P-coil for the adjustment the P-coil across the whole range
0 Coil backlash
0 P-coil overrun
0 Checking the correct movement direction (up down)
0 Detection wiring errors the position detector’s range
0 Non-linearity behaviour the potentiometer
Calibrating the coil
When calibrating the coil, the system first searches for the 'Lower' end switch.
10.Page Commissioning
We take care it. Once that's done, the coil backlash and coil over-
run are determined the middle the adjustment range.2 Automatic coil calibration the REG-DP/ REG-DPA
(<MENU><F3><F3><F5><F3>)
Pressing <F2> starts the automatic coil calibration during which the below P-coil data are
determined the regulator. The P-coil then set the
lower end position preparation for linearization. The P-coil is
then adjusted the 'Higher' end switch.
Successful coil calibration displayed the screen follows:
