this case, injection without component not possible.
In this case, the measurement signal calculate the grid parameter will get smaller
Default setting: NOT active not earthed)
0 Manual CI
The parameters for manual current injection can also set.
13.
.2 Parameters the Commissioning menu
All the other parameters that are needed ensure that the current injection functions
properly are set here. This point only interesting
during commissioning.
If the parameter enabled, the REG-DP/ REG-DPA will assume that the PAW directly
earthed.8. This where the measured values can checked using the WinEDC
service screen and the manually startable current injection.2.Page 202 Commissioning current injection
We take care it.8.3 inject a
measurement signal with without component.
13.1 Subsequent item Current injection
0 Parameter sets
– Injection location (PAW) earthed
This parameter refers the current injection feature described Chapter 13
