75 UserBOF2
76 UserBOF3
77 UserBOF4
78 UserBOF5
79 UserBOF6
80 UserBOF7
81 UserBOF8
82 EOR_missing Only for 'EOR' feature
83 noSlave Message: Slave regulator parallel program master/slave miss-
ing
84 Tuned_Umax_en
d
P-coil 'tuned' positioned 'Umax_End' (new from firmware
V2.Page 142 Detailed description REG-DP/ REG-DPA parameters
We take care it.
The following four parameters apply all relay outputs equally.00)
86 HPCI_Puls HPCI: Pulsing active.
0 Minimum idle time relay
Defines the minimum switch-on time for relay signal
Default setting: s
0 Impulse progr Mot H/L
The external (SCADA system) higher and lower commands for the motor are extended by
this value.
Note: AUTO mode including coil detuning and move back
87 HPCI_local HPCI: Location/Remote switch CIC set 'Local' and commu-
nication with CIC works
88 HPCI_Remote HPCI: Location/Remote switch CIC set 'Remote' and com-
munication with CIC works
89 CI_Status Signal active, when sends “Status OK” and communication
with works
90 CI_SearchBlock Signal active, when sends “Search blocked” and communica-
tion with works
91 HPCI_PulsBlock Signal active, when HPCI sends “Pulse blocked” and communica-
tion with works
.00)
= (BOF BOF 55) AND BOF 54
85 Tuned_v_invers P-coil 'tuned.nc' and the wrong side the resonance curve
(new from firmware V2. This, combination with impulse commands from the SCADA system, ensures
that the coil moves smoothly
Default setting: s
put function (BOF) OR-gate.4.4
