23 R_auto_on Message: Resistance control has been activated.
24 R_block Message: Resistance control active but blocked. The menu and the different display
modes can still used. s). The
'Motor Higher' and 'Motor Lower', 'MAN' and 'AUTO' keys the
regulator are blocked the software.
27 PotiWarning Message: Pot measured value not plausible (pot has 'gap' at
this location).
22 Coupling Message: Parallel operation P-coils; corresponds forwarding
input function '29: Coupling.
34 Error Error message: Summary message for known errors:
0 Motor error
– movement adjustment command (33:E:Move)
– Wrong direction (32:E:Dir)
0 Potentiometer error
– Cable break (39:PotError)
0 Both end switches are recognized the same time
0 Positioning error
0 P-coil error message (BIF 10:E:Error )
35 Error_td Delayed summary error message
36 Error_Sum Error collective message
ErrSum
0 Error Alarm Status
0 (34:Error) (BOF 29:Alarm)
0 (BOF 4:EMERGStatus)
Alarm:
.Page 139
Detailed description REG-DP/ REG-DPA parameters
0 Search aborted
19 Homepos2 Reserved
20 Remote Message: The regulator was switched into 'Remote' mode.
28 SIM Internal grid simulation has been activated.
29 Alarm Alarm collective message:
0 SearchTime exceeded (BOF 38:T_MotOn)
0 NumberSearch exceeded (BOF 37: search)
0 responsive (BOF 64: CI_missing)
0 measured value too small
0 slave responsive (BOF 83: Slave missing)
30 Alarm Alarm collective message delayed
31 AlarmInt Reserved
32 E:Dir Message: P-coil moving the wrong direction
33 E:Move Message: P-coil adjustment 'Motor Higher' 'Motor Lower'
command was not detected within defined period (ca.
25 R_on Command: Turn resistor for resistance control
26 R_T>> Message: Resistor too hot.
21 Fix coil Message: The fixed coil taken into account when calculating the
compensation. The signals are not physical-
ly separated from the P-coil
