Petersenova cívka s regulátorem REG-DP

| Kategorie: Leták / Datasheet  |

Operating Instructions for the Petersen-Coil Regulator

Vydal: EBERLE Controls GmbH

Strana 126 z 272

Jak získat tento dokument?






Poznámky redaktora
If the slave readjusted the master, the slave will display message indicating that is being positioned the master: 'Positioning slave' 0 End parallel operation Master The regulator leaves the 'Master' state and starts the search process after the long delay time the trigger threshold was violated the switching operation. slave that MAN mode cannot adjusted the master. 0 Earth fault behaviour – Slave blocked – Only the master readjusted according the setting the menu: . Figure 89: Setting the coupling function binary input 12 0 Behaviour with active parallel regulation with communication The master detects the parallel operation, displays its display and informs the slave regulator that now its slave. MAN mode takes precedence. The slave also activated when MAN mode. However, the master not allowed to adjust the slave even this option active and the 'Slave' not displayed. The slave shows its 'slave state' its status bar. Slave AUTO mode Slave leaves its state and starts its search process after the short delay time. The slave sends the current position the coil and any active fixed coils the master through the E-LAN.Page 126 Detailed description REG-DP/ REG-DPA parameters We take care it. The slave must AUTO mode. The slave receives this information cycles during parallel operation. soon this information longer transmitted, the slave becomes inde- pendent regulator again