40°C its
maximum temperature.
0 Max switch-on time
Maximum duty cycle for the resistor Une 100% which heats from ca.
Default setting: s
0 Max temperature
A maximum permissible nominal temperature must set calculate the resistor's ther-
mal capacity.
Default setting: min
Binary input functions:
Description Description
R_auto_on Resistor control on: The resistor control activated impulse
R_auto_off Resistor control off: The resistor control deactivated impulse
R_auto_onoff The on-state the resistor control changes with each impulse this input line
R_block The resistor control blocked
S:BlockT Simultaneous blocking the resistor control and the regulator, for example, due
to overheating the P-coil (Buchholz relay)
R_start Resistor control triggered manually (The rising edge this signal evaluated)
Relay output functions
Description Description
R_auto_on The resistor control active
R_T>> The resistor too hot (triggered the internal thermal replica)
R_on Command turn the resistor
R_block Summary message the blocking the resistor control The resistor blocked
either the thermal replica binary input the SCADA system.Page 122 Detailed description REG-DP/ REG-DPA parameters
We take care it. This applies
to ambient temperature 30°C. (BIF25:
R_block BIF19: S:Block_T)
The resistor control activated one the following events:
0 From the regulator's menu
0 Impulse from the binary input function R_auto_on
0 First impulse from the binary input function R_auto_onoff
0 Switch-on command from the SCADA system
The resistor control deactivated one the following events:
.
Default setting: 200°
0 Cool-down time
Time needed cool down the resistor from its maximum temperature 40°C
