Only active when the parameter Repeat cycles 0
0 Default value: s
0 Standby state Une Uerd:
.
0 Switch-on time
The resistor's duty cycle
Default value: s
Automatic repeat cycle:
The parameter Repeat cycles used set the number cycle repeats for the Repeat de-
lay and Repeat time.
The thermal replica also used check the resistor has switched again for these cycles. one the set values bigger than zero, additional resistor
connections will triggered after the first residual current increase that was automatically
triggered the earth fault.
0 Repeat delay
The time delay for the repeats can set irrespective the delay for the first cycle.
0 Repeat cycles
Number cycles, how often the resistor should automatically switched and OFF.Page 119
Detailed description REG-DP/ REG-DPA parameters
0 Active
Activates the resistor control and the following settings
Default: Inactive
0 Switch-on delay
Time delay switch the resistor
Default value: s
Note:
The inherent time the resistor control can 1500 ms.
Default value: inactive)
There are repeats when this parameter set 0.
Default value: s
0 Repeat time
0 Total time for all repeats
