Default setting: min inactive)
Note:
Values smaller than min are invalid. The tolerance range only consists the
absolute value the zero sequence voltage. The size the tolerance range does not change.Page 102 Detailed description REG-DP/ REG-DPA parameters
We take care it.
0 Avoid resonance peak
The coil started the opposite direction and reversed necessary the system can
search the falling edge (away from the resonance point). essentially impacts the tolerance range and the number identified
grid switches. This function does not help with fast zero sequence
voltage changes.
0 Check resonance curve:
If the regulator displays 'Tune' and this parameter set, tolerance threshold placed
around the determined resonance curve.)
.
After the first estimate has been determined the falling edge, the direction changed
and new, normal search started the direction the resonance curve.
0 Adaptation Uref:
Grid switches are always relatively fast and over within few minutes.
Note:
This setting makes sense the grid conditions are very unbalanced, meaning that there are
very high zero sequence voltages the resonance point.3. the zero se-
quence voltage does not leave the tolerance field during the set time, the current zero
sequence voltage will adopted the new reference voltage the end this observa-
tion period. The number
of searches can reduced when the tolerance for slow changes adjusted.
NO The angle measurement supressed. (often cable networks)
0 Une angle measurement
Parameters Description
YES angle measurement performed when the synchronization voltage con-
nected. contrast, changes
due weather and crosstalk from load current changes are usually very slow.
In this case, the 'Forced search delay' used delay time (see section 11. This occurs frequently compen-
sated 110 overhead transmission grids.
The parameter 'Exceed resonance peak' usually disabled,
meaning that the resonance point not exceeded unless has for tuning.1. the measured value leaves this tolerance range
(due switching), the search aborted and new search started. The coil is
positioned the determined tuning point after the first estimate has been completed.1
