Remember shot down the power. Open the front panel and take out the filters.
Service
If you are unable maintain your unit yourself, you
can sign service agreement with the Genvex service
department. After
changing the filters, switch off the filter timer.
GE Energy and 3Optimum initial adjustment plant
Air measuring equipment used. the condensate drain does
not work, this could lead water damage the dwelling.
Do not vacuum clean high air pressure.Subject Technical Modifications Energy and 3/GES Energy 1
Condensate drain:
When changing the filter August/September,
before outside temperatures falls 5°C, check the
condensate drain for blockage dirt and check that
there water the water trap. they are
dirty they may cleaned with brush, bottle washer
etc. it
is dirty, remove and wash warm soapy water and then
rinse, possibly the bathroom using the shower head.3 Filter alarm.
Before starting initial adjustment, check that the points
in the inspection and initial adjustment section have been
carried out.
They have sharp edges and must not be
damaged. Make sure the
valve does not rotate, causing change the air volume.
Stop the unit the power switch the unit the
board. Change the
filters and reset the filter timer.
Fans:
Every year check the two fan wheels for dirt.
G4 Standard filter
(Coarse filter class G4)
F5 = Fine filter (Fine filter class F5)
F7 = Pollen filter (Fine filter class F7)
100 mm
Vandl s
Til indvendig aflłb
Water trap
Indoor drainpipe
.
It will damage the filter!
Careful handling the plates required.
Maintenance the unit with the control
Optima 100 DESIGN
Turn off the electricity for the unit before
opening it
Filters:
When the LED for changing the filters flashes in
the display the control panel, the filters must be
changed.
Stop the unit the power switch the unit. any faults arise the unit, contact the
Genvex service department. Then start the unit:
Maintenance the unit with the control
Optima 250 DESIGN
Turn off the electricity for the unit before
opening it
Filters:
When the alarm ”change filter” flashes the display of
the control panel, the filters must changed.
Pour litre water into the condensate tray and make sure it
can run off without problems.
If you want change the interval for cleaning the filters,
this can adjusted the operating instructions under
section 3.
Countercurrent heat exchanger:
Inspect the countercurrent heat exchanger every year.
Supply and extract valves:
Clean the valves wiping with dry cloth.
If you want change the interval for cleaning the filters,
this can adjusted the user menu, item 5
