Poznámky redaktora
IEC) and
ABB quality assurance procedures (ISO 9001).
Every component drive subjected
to thorough testing verify that quality
standards and customer requirements are
fully met. Routine tests and functional tests
form integral part the scope supply
of MEGADRIVE system. one converter/motor
combination drives similar combination in
a generation mode.
Special and performance tests
At the customer's request, special tests the
complete drive system can carried out to
check the noise level, short-circuit capability,
electromagnetic compatibility (EMC) etc. ABB has adequate
facilities perform all these tests. They are carried out accordance
with international standards (e.
Routine tests
Every component sub-system drive
is tested part the normal production
process.
Large units are tested «back-to-back»
(see picture above), i.g.
Load tests
Major components,
sub-systems the
complete drive are
tested load to
verify power or
current output at
rated and overload
operating points
under defined
cooling conditions.
18
.
Routine testing a
frequency converter.e.
The associated converter
cubicles and supply
transformers can seen
behind the two motors.MEGADRIVE-LCI under test
Back-to-back testing of
two high-speed (6000 rpm)
10 MEGADRIVE-LCI
drives ABB's motor works
at Birr Switzerland.
If desired these tests
can also verify the
efficiency the item concerned (segregated
loss method). Where additional
tests such load tests, combined tests or
special tests are considered necessary,
they should agreed early possible.
Combined tests
For newly developed systems the
customer's request, the frequency converter
is tested combination with motor the
works verify its performance and that it
conforms the design data
