Petersenova cívka s regulátorem REG-DP

| Kategorie: Leták / Datasheet  |

Operating Instructions for the Petersen-Coil Regulator

Vydal: EBERLE Controls GmbH

Strana 57 z 272

Jak získat tento dokument?






Poznámky redaktora
0 Firmware error– the firmware doesn't match the used hardware 0 (current injection) not available 0 Blown fuse These messages display until the cause the error has been fixed.6. 9. If several error messages are displayed, use the keys scroll through them. All acknowledgeable errors are reset the same time. Press <F5> acknowledge error message. .1 Non-resettable errors/critical errors are: 0 Status LED extinct the device must sent for inspection.Page 57 Operating the REG-DP directly Earthflt Number earth faults Time earth fault that longer than the set transient time Iw-Incr Number residual current increases When the additional resistor controlled the REG-DP Trigger Number search triggers The regulator goes into search mode; the regulator doesn't actually have to search for anything the original Uen value reached within the time delay SeachCI Number searches with optional current injection Note: This does not change the coil position externalCI Number external current injection requests; typical with EOR-DM (in EDCSys) for the admittance technique for earth fault detection 9.4.6 Troubleshooting Figure 39: Troubleshooting (REG-DP error messages) Errors are displayed the status bar soon they occur. Detailed information ob- tained pressing <MENU> <F5>.4