recommended that this work be
carried out the Eberle home office.4.4)
Point 100 100 according the maximum value Une the x-axis
Point 0.
Nominal value Maximum value that the module can physically deliver.50 the y-axis corresponds 50% (standardized
0. this not the case, rewiring has done.
The REG-DP has total three slots for the analogue module.
0 100 Une [V]
10
0
10
8
mA
0 100 Une [V]
10
0
50
40
y [%]
Figure 98: Knee-point characteristic (magnifier) for analogue module
Parameterization using the menu:
Menu item Value Function
Type Output output module used.8 Retrofitting analogue channels
Please check first whether the housing the subrack has the wiring for the analogue chan-
nels. because can retrofit the REG-DP with the an-
alogue channels the same time.4 the y-axis corresponds 40% (standardized 0.
The standard modules deliver mA
Function Une Allocation the desired 'analogue measured value' for the output
(see above table)
Point corresponding the smallest value Une the x-axis
Point the y-axis corresponds mA
Point according the knee-point the x-axis
Point 0.1. The 100 range displayed the remaining 10
mA range.
.
11.50)
You can use the service screen and the Override function described Chapter make
sure that the analogue outputs have the right transmission function.Page 149
Detailed description REG-DP/ REG-DPA parameters
Example for knee-point characteristic (magnifier):
The figure shows the magnified voltage range from The range dis-
played the range.
If the housing/subrack already wired for analogue channels, the analogue channels can
be retrofitted according the below instructions
