Insert (2) and (3)
with control button.
When connecting the wind sensor, use shielded line (we recommend
JY-ST-Y 0. For this reason, the blind cannot be
operated manually automatically.
Note
Glass-breakage sensors may not used together with the wind sensor. Observe connection values the circuit breakers. Motors M1
(insert (2)) and (insert (3)) can also operated manually via the con-
trol buttons. The automatic
and manual control both motors additionally carried out “centrally”
via insert (4) with electronic blind controller.
(4) (1) (2) (3)
Connection blind controller insert with “central control”
The connection several phases enables the central control be
installed another level another room. Additional inserts can added, accordance with the
wiring diagram. The line may not laid together with 230V cables
(risk interference).
Observe connection values the circuit breakers. The automatic and manual control both motors is
performed “centrally” via insert (1) with electronic blind controller. not install location that sheltered from
the wind. This enables joint down movement the connected
motors (e.
.
Both motors are operated simultaneously via insert (1).655
Gira electrical installation systems
Inserts sensors Blind controller
I
Technical
information
Connection group control central control
(1) (2) (3)
Connection blind controller insert with “group control”
For example: Insert (1) with electronic blind controller.
AC 230 V~
AC 230 V~
AC 230 V~
0398 00
1
0398 0398 0398 00
0398 0398 0398 00
2 3
4 5
Connection blind controller wind alarm (central control with two groups)
With wind alarm, the blind raised and remains locked there until the
wind dies down. Ensure attachment the correct position.
Additional inserts can added, accordance with the wiring diagram.
Note
As long raise command active auxiliary input “2”, the blind
cannot operated manually automatically the device itself. central raise command the morning and central lower
command the evening for all connected blind motors). The
wind sensor must attached position that conducive wind-
speed measurement.
The wind-protection function (blind moves up)
is blocked after glass broken and the blind shutter remains closed. central
raise command the morning and central lower command the
evening for all connected blind motors). This locking remains effect long raise com-
mand active auxiliary input “2”. Insert (4) with elec-
tronic blind controller.
Note
As long raise command active auxiliary input “2”, the blind
cannot operated manually automatically the device itself. This enables the simulta-
neous down movement the connected motors (e. Example with two blind
motors: Insert (1), (2) and (3) with control button.
The switching commands are evaluated the same way for both
motors. Motors (insert (2)) and (insert (3)) are
operated manually via the control buttons.6). g. g.
Connection wind alarm
Connection blind controller wind alarm
Wind sensor (cup anemometer)
The wind sensor installed the roof the side the building. The switching commands
are evaluated the same way for both motors
