The device certificate then entered.mdt.4.
2. The device will reset and reboot.4 Reset factory settings
If the device has already been use the initial start-up has failed, must reset factory settings
according the following procedure. you cancel this point, the device will loaded without KNX Secure functions.4 Reset factory settings
Figure Commissioning with ETS Security: Add device certificate
2.
Add device certificate
1.4. webcam connected, this can done scanning the QR
code; alternatively, the certificate can entered via the keyboard.4.3 Commissioning with activated KNX Secure
When importing the application program into the KNX project, message appears indicating the need for a
project password.MDT technologies GmbH Papiermühle 51766 Engelskirchen Germany
Telephone: +49 (0) 2263 880 knx@mdt.
2. The LED switches off when you release the button.1.01S]
State
12/2025
-
Version
1.3.
Once you have the certificate, you can now scan the code enter manually. Press and hold the programming button for least seconds.
Do not ask when adding devices Later
OK
. Now briefly release the button and press again for least seconds until the programming LED
flashes rapidly.2 [Device name]
This device supports secure commissioning.de 19
Technical Manual
KNX RF+ Window Handle, Secure [RF-FGxS.
1.0
2.de www.
3. The programming LED flashing
