• Place the window handle onto the window profile and secure with the appropriate screws.
• Release the grub screw the handle the MDT RF+ window handle. Configure settings the application programme and program.
3. After programming, reposition the rosette aligned cover the baseplate allows snap into position. (The red programming LED lights continuously).4.de 19
Technical Manual
KNX RF+ Window Handle, Secure [RF-FGxS. this mode, data cannot received.de www. Ease the rosette off the base plate towards the handle and then rotate 90°.
2.
Note: recommendable proceed with commissioning before replacing the cover rosette.
2.0
2. Adjust the length the square spindle:
• Find out the length the square spindle the existing window handle.
3.4.mdt.
• Tighten the grub screw the MDT RF+ window handle again.
• Set the square spindle the same length the previously installed window handle. Remove the existing handle:
• Move the handle horizontal position ("3 o'clock" o'clock" position).
6.
• Ease the rosette off the base plate towards the handle and then rotate 90°.
4.
2.
. Install MDT RF+ window handle:
• Move the handle the MDT RF+ window handle horizontal position ("3 o'clock" o'clock"
position). Set and program the physical address the ETS (the programming LED switches off).
• Remove the window handle according the manufacturer's instructions.4 Commissioning
2.1 Assembly
1.
1.MDT technologies GmbH Papiermühle 51766 Engelskirchen Germany
Telephone: +49 (0) 2263 880 knx@mdt.2 Commissioning KNX RF+ device
Note: start with ETS, you need have RF+ radio line coupler the KNX topology that's enabled
to add devices. For square spindle mm: use
60 (top bottom).
5. Press the programming button. Pay attention correct polarity.01S]
State
12/2025
-
Version
1. ensure reliable
telegram transmission, recommended that the device set programming mode before the
application programme transferred.
Note: The device may ‘deep sleep mode’. Insert batteries. For a
square spindle 32–37 mm: use (top bottom)
