send cyclically" parameters, common parameter "cycle time"
appears, which defines the transmission interval for all the maximum status messages transmit-
ted cyclically.0
Advanced settings
In the standard application, adjustment the messages from the window handle required...mdt. Name/Object function Length Usage
2 Window position closed open Bit Status message
3 Window tilt position not tilted tilted Bit Status message
4 Handle position Position value Byte Output the handle position
6 Message when window "open" Status Bit Status message
Table Communication objects Handle positions
.01S]
State
12/2025
-
Version
1.
Cycle time
After activating least one the ".
Note: Short intervals shorter battery life.g. with roof windows), each handle position can individu-
ally configured the advanced settings.de www. This
means that for the handle positions "open" "tilted", the value "0" transmitted instead the standard
value "1".
Value for open/tilted
If required the application, the polarity the message can reversed using this parameter. The tilted state only indicated when the handle the upward position. The
window indicated open when the handle points the left, right top, and closed when the handle
points downwards. The transmission only starts when the window status ‘open’ “closed” has not
changed for the time set under "Delay time".
The following table shows the associated communication objects:
No.MDT technologies GmbH Papiermühle 51766 Engelskirchen Germany
Telephone: +49 (0) 2263 880 knx@mdt.de 19
Technical Manual
KNX RF+ Window Handle, Secure [RF-FGxS. This message can reversed using the "Value for open"
parameter.
Message when window "open"
When the parameter activated, new communication object appears which sends the window status
"open" and "closed". the
actual states the window differ from this (e.
Send window position (tilt position) cyclically
By activating these parameters, the respective communication object sent cyclically
