." →
"active".
Only "Ready receive data after ." →
"active"... activated, “ON” telegram is
sent cyclically.. This
means the device remains ready receive for defined period order process any immediately
following telegrams feedback.
Table General settings
Send "In operation" cyclically
The “Operating” object used show the bus that the device alive..2 ETS parameters
3.
Note: Short intervals shorter battery life.de 19
Technical Manual
KNX RF+ Window Handle, Secure [RF-FGxS..
Duration 00:01 .
Only "Send 'In operation' cyclically" →
"active"..
Duration 00:01 ." →
"active".
Only "Send 'In operation' cyclically" "active"
Cycle time 00:05 ..
Ready receive data
after "In operation"
■ not active
■ active
Delays the deactivation the receiver after
the "In Operation" transmission....
Ready receive data
after handle movement
■ not active
■ active
Delays the deactivation receive mode after
a handle movement. 24:00 hh:mm
[05:00 hh:mm]
Setting the transmission interval.1 General settings
The following table shows the available settings:
ETS text
Dynamic range
[Default value]
Comment
Send "In operation"
cyclically
■ not active
■ active
Activation object.
Duration 01:00 .. 04:00 mm:ss
[03:00 mm:ss]
Duration the delay.
Only "Ready receive data after .
Ready receive data after after "In operation" handle movement restart
This parameter delays the deactivation reception readiness after sending the respective message..MDT technologies GmbH Papiermühle 51766 Engelskirchen Germany
Telephone: +49 (0) 2263 880 knx@mdt.
Ready receive data
after restart
■ not active
■ active
Delays the deactivation receive mode after
a restart...de www.mdt.2.01S]
State
12/2025
-
Version
1.0
3. 15:00 mm:ss
[05:00 mm:ss]
Duration the delay.
Only "Ready receive data after . 04:00 mm:ss
[03:00 mm:ss]
Duration the delay
