this not heeded, defects may arise the Gira
Tronic transformer due voltage spikes when switching the circuit.
Installation instructions
Tronic transformers are spike-resistant accordance with 61047. Underload could lead flickering. distance to
earthed surface: 40cm
Permissible number of
secondary lines: 1
Technical data
1–10V interface
Control voltage: 10V
Control current: approx.5 148 60
0375 200W 4.651
Gira electrical installation systems
Tronic transformers
I
Technical
information
Tronic transformers
Dimensions
Transformer Dimensions (mm)
(A) (B) (C) (D) (E)
0367 40W 3. 0.5mm² VV-F 2×1.
Short-circuit protection (40/70/105/150W transformers)
Switch-off with automatic restart after elimination short circuit.5 55
0365 105W 4. +100°C
Potentiometer for 1–10V interface with Tronic transformer with integrated 1–10V
control unit
The 1–10V top unit allows control the Tronic transformer via the
1–10V interface.
Power per cable Cable cross
section
Secondary line
recommendation
≤ 35W 0. Overload and excess-temperature protection via auto-
matic power reduction (40/70/105/150W transformers) switch-off
until cool-down (200W transformer).
Note output range the transformer. +50°C
Housing temperature (Tc
): max.5 148 54
0373 150W 4. 200W transformer also
suitable for 230V. Can dimmed with Gira Tronic dimmer
and Gira universal dimmer (trailing edge dimmer). 0359 00
Technical data
Rated voltage UN
: 230V~, 50Hz
Rated output: 105W
Output voltage: 11. Any other
switch-off remains until manual switch-on.5 181 63
(A)
(B)
(C)
(D)
(E)
Minimum ceiling opening (E) with standard intermediate ceiling height 78mm.5mm²
155W 200W Power divided over least cables.8mA
Electrical isolation 1–10V: 2kV basic insulation
Ambient temperature (Ta
): max.5mm²)
Function
Insert for 12V halogen lamps. Bulb-saving switch-on
due soft-start.
Short-circuit protection (200W transformer): Switch-off with automatic
restart after elimination short circuit within five seconds.5mm²
110W 105W 2.
Tronic transformer with
integrated 1–10V control device
Order No.75mm²
40W 105W 1. Control occurs via 1–10V control unit such the
built-in control unit for 1–10V, electronic potentiometer for 1–10V con-
trol input System 2000 1–10V control unit insert.
Install isolated load circuit protect against overloads (caused by
switching fluorescent lamps, discharge lamps, motors and other induc-
tive loads) for Gira Tronic dimmers, Gira universal dimmers and Gira
Tronic transformers.5mm² VV-F 2×2.5 53
0371 105W 3.7 Veff,
~ 40kHz
Primary current: 0.5 3. (at
least 2×1.4 3. length the
secondary line: 2m
Min.
AC 230 ~
Control unit for 1–10V with Tronic transformer with integrated 1–10V control unit
.45A (105W)
Max.75mm² VV-F 0.4 40
0366 70W 3
