8
95 P25M P25D 13.
The measurements are compared the
table below.0
1000 W60M W60D 36.3
185 P32M P32D 18.8
25 P13M P13D 6.0
630 W60M W60D 36.5
6 C16-25 15.12:5
12
Oval crimping
For branching sleeves, the ”h”
dimension must checked.8
50 P20M P20D 10.4
300 P36M P36/40/44D 21.5
21 C240-300, C23 54.
Crimp die table type AK/AS (T-measurement)
Type AS/AK/AKK Tools
AS/AK/AKK Matrix Punch max mm
16 P13M/TP13M P13D/TP13D 6.5
400B 13P37M/P2537M 13P37D/P2537D 22. This done
at the maximum height the crimped
oval, preferably with calipers.0
.0
800 W60M W60D 36.0
13 C50-70, C70-95 26.8
35 P20M P20D 10.5
150 P25M P25D 13.5
15 C95-120 30. the ”T”
measurement exceeded, after indented
crimping, contact the nearest Elpress
service centre.8
70 P20M P20D 10. This is
best done with special calipers, contact
Elpress necessary.0
1200 W70M W70D 41.5
120 P25M P25D 13. See measurement points
on the image below. the ”h”measurement is
exceeded, after contact crimping,
contact the nearest Elpress service centre.5
8-9 C25-50 22.
See measurement points the image
below.5
500A P2552M P2552D 31.8
18 C150-185 44.0
630A P2552M P2552D 31. Sleeve max mm
5 C6-10 12.5
400 P40M P36/40/44D 22.0
300B 13P37M/P2537M 13P37D/P2537D 22.4
Indent crimping
For terminals, the measurement ”T”
must checked, which measured at
the bottom the indent that the punch
has achieved the terminal.8
500B P44M P36/40/44D 24.5
150SOLID 13P29M 13P29D 14. Compare measured
”T”measurement with table.4
240 P32M P32D 18.
Crimp die table type sleeves
(H-dimensions)
C-die No
