1
ca. Enter the flange with cautious rotation while
holding back the shield mesh. this step, not enter the
flange completely but keep approx.10
121
www. Slip the crimp flange over the conductors and possible inter-
mediate layers and slide underneath the shield mesh and the
cable sheath.com
1. longer than the jacket. Cut off any overlapping braid around the flange.
3.10
1
ca. Fold back the braid over the cable sheath and slide the crimp
ferrule the cable.inotec-electronics. distance the ca-
ble sheath order facilitate the cutting the shield mesh.
4.
2.10
1
ca. The faces the hexagon should parallel
to the straight sides the crimp flanges (see illustration).
Please note: Our insertion tool CFE facilitates the handling of
the flange step and 4. Slide the crimp ferrule forward until contact with the
flange. Keep position and crimp with the indicated
crimp dies.
Variations cable construction materials may require the
processing following different assembly procedures.
Standard assembly procedure KV0001
The standard procedure described below allows easy and re-
liable assembly process for the major part all shielded cables. Only now
slide the crimp flange completely underneath shield mesh and
cable sheath. Dismantle the cable down the braid and cut the braid,
leaving approx.10
1
ca.
Important: During the crimping process the flange has lay
on the crimp dies.
5.
With the cable-specific crimp data definition determine the
required assembly parameters, component diameters and tool
sizes for every specific application service for our customer
(see facing page).
Original Inotec crimp flange system
.10
1
ca
