ABB Softstartéry - komunikace (EN)

| Kategorie: Leták / Datasheet  | Tento dokument chci!

Vydal: ABB s.r.o, ELSYNN Autor: ABB ELSYnn

Strana 208 z 225







Poznámky redaktora
eds CU 03.eds CU 05. • Switchingfrom one type control another (fieldbus control hardwire control) • Re-programming the programmable inputs • Reset all Settings (programmable input set Enable) 1SFC132052M0201. For technical data and descriptions the DeviceNet fieldbus plug, see document 2CDC193001D0203, available www.03.eds CU 04.04 EDS_PST_7_0.05.eds CU 05.01 and 03.eds CU 03.03. To the programming the PLC, following EDS files are available: Softstarter CU-version EDS file CU 02.eds ACaution! The motor may start unexpectedly there start signalpresent when doing any the actions listed below.02 EDS_PST_4_7.01 EDS_PST_Rev4_0. Through the fieldbus ispossibleto start and stop the motor, perform jog, sequence start, read out currents and frequency, achieve information about protections, warnings, faults and much more.02 EDS_PST_5_0.02.eds CU 05. See chapter “Setting and configuration” the installation manual for programming the inputs outputs.04.00 EDS_PST_Rev4_5. Before the DeviceNet fieldbus can taken operation following parameters must set the softstarter: ■ Parameter Fieldbus Ctrl set Yes ■ Parameter Fieldbus Type set other ■ Parameter Fieldbus Addr set free communication address.03 EDS_PST_6_0.00.00.abb.DeviceNet The DeviceNet protocol fieldbus protocol that provides full controland status information the softstarter as well reading and writing parameters.02 EDS_PST_Rev4_4.com/lowvoltage .04