ABB Softstartéry - komunikace (EN)

| Kategorie: Leták / Datasheet  | Tento dokument chci!

Vydal: ABB s.r.o, ELSYNN Autor: ABB ELSYnn

Strana 140 z 225







Poznámky redaktora
03.03 which can checked the softstarter display Menu STATUS INFORMATION Ver xx.com/lowvoltage . Note that the set-up varies depending used softstarter version and this document describes the softstarter software version 05. For technical data and descriptions the Modbus fieldbus plug, see document 2CDC194001D0201 available www. Please check which the actual softstarter version your case. Before the Modbus fieldbus can taken operation following parameters must set the softstarter: ■ Parameter Fieldbus Ctrl set Yes ■ Parameter Fieldbus Type set other ■ Parameter Fieldbus Addr set free communication address. ACaution! The motor may start unexpectedly there start signalpresent when doing any the actions listed below. See chapter “Setting and configuration” the installation manual for programming the inputs outputs. • Switchingfrom one type control another (fieldbus control hardwire control) • Re-programming the programmable inputs • Reset all Settings (programmable input set Enable) 1SFC132047M0201.xx.xx..abb.Modbus The Modbus protocol are fieldbus protocols that provides full control and statusinformation thesoftstarter as well writing parameters. Through the fieldbus possible startand stopthe motor, perform jog,sequence start, read out currents and frequency, achieve information about protections, warnings, faults and much more