Fixed wiring OK.
If necessary
Contact Hager technical support
service deeper investigation is
needed.
Series Arc Fault
1 .
Replace the appliance(s).
Trying repeat the tripping
circumstances.uk
.Arc fault troubleshooting
Handle OFF. firmware update avaible. Measure the insulation resistance.
______________ I
2.
Perform the firmware update.
Identify the fault and
repair the circuit. Tripping circumstances are not clearly identified.co.
AFDD trips.
Check the appliances.
B Make sure that the
handle OFF.
Connect and activate applicances
one one, then all together.
03 Hager technical support: +441952675689 technical@hager.
Disconnect all appliances
that can damaged during
the insulation test. Measure the insulation resistance.
2 .
Appliances are OK.
Tripping circumstances are identified.
Parallel Arc Fault
LED blinking RED
1. AFDD doesn’t trip.Connect and switch a
resistive load 1000W the
different sockets the circuit
one one.
Check the appliances.
Replace one (several) involved
appliance(s), move (them) to
another circuit temporary.
If the measured value
smaller than MQ.
► Check firmware update
A firmware update avaible.
If the measured value
bigger than MQ. Appliance(s) is/are not OK.
Check the fixed cables of
the installation.Disconnect the appliances of
the protected circuit
