Poznámky redaktora
eds
CU 04. Through the fieldbus ispossibleto start and stop the motor, perform
jog, sequence start, read out currents and frequency, achieve information about protections, warnings, faults and
much more.04.eds
ACaution!
The motor may start unexpectedly there start signalpresent when doing any the actions listed below.eds
CU 03.02 EDS_PST_Rev4_4.05.01 and 03.
Before the DeviceNet fieldbus can taken operation following parameters must set the softstarter:
■ Parameter Fieldbus Ctrl set Yes
■ Parameter Fieldbus Type set other
■ Parameter Fieldbus Addr set free communication address.00.
• Switchingfrom one type control another (fieldbus control hardwire control)
• Re-programming the programmable inputs
• Reset all Settings (programmable input set Enable)
1SFC132012M0201.DeviceNet
The DeviceNet protocol fieldbus protocol that provides full controland status information the softstarter as
well reading and writing parameters.00 EDS_PST_Rev4_5.
For technical data and descriptions the DeviceNet fieldbus plug, see document 2CDC193001D0203,
available www.02 EDS_PST_4_7.eds
CU 03.00.01 EDS_PST_Rev4_0.
See chapter “Setting and configuration” the installation manual for programming the inputs outputs.abb.com/lowvoltage .
To the programming the PLC, following EDS files are available:
Softstarter CU-version EDS file
CU 02.03