ACaution!
The motor may start unexpectedly there start signalpresent when doing any the actions listed below.01and 03. Please check whish the actual softstarter version your case.
Before the Modbus fieldbus can taken operation following parameters must set the softstarter:
■ Parameter Fieldbus Ctrl set Yes
■ Parameter Fieldbus Type set other
■ Parameter Fieldbus Addr set free communication address.00 which can checked the softstarter display Menu STATUS
INFORMATION Ver xx.
• Switchingfrom one type control another (fieldbus control hardwire control)
• Re-programming the programmable inputs
• Reset all Settings (programmable input set Enable)
1SFC132021M0201.05.abb.04. Through the fieldbus possible startand stopthe motor, perform jog,sequence
start, read out currents and frequency, achieve information about protections, warnings, faults and much more.Modbus
The Modbus protocol are fieldbus protocols that provides full control and statusinformation thesoftstarter as
well writing parameters.
For technical data and descriptions the Modbus fieldbus plug, see document 2CDC194001D0201
available www.com/lowvoltage .xx..xx.
See chapter “Setting and configuration” the installation manual for programming the inputs outputs.
Note that the set-up varies depending used softstarter version and this document describes the softstarter
software version 03
