Poznámky redaktora
01 EDS_PST_Rev4_0.eds
CU 05.
Before the DeviceNet fieldbus can taken operation following parameters must set the softstarter:
■ Parameter Fieldbus Ctrl set Yes
■ Parameter Fieldbus Type set other
■ Parameter Fieldbus Addr set free communication address.02.
For technical data and descriptions the DeviceNet fieldbus plug, see document 2CDC193001D0203,
available www.02 EDS_PST_Rev4_4.eds
ACaution!
The motor may start unexpectedly there start signalpresent when doing any the actions listed below.03.
• Switchingfrom one type control another (fieldbus control hardwire control)
• Re-programming theprogrammable inputs
• Reset all Settings (programmable input set Enable)
1SFC132049M0201.DeviceNet
The DeviceNet protocol fieldbus protocol that provides full control and status information the softstarter as
well reading and writing parameters.eds
CU 05.com/lowvoltage .
To the programming the PLC, following EDS files are available:
Softstarter CU-version EDS file
CU 02.02 EDS_PST_5_0.03 EDS_PST_6_0.eds
CU 04.02 EDS_PST_4_7.00.
See chapter “Setting and configuration” the installation manual for programming the inputs outputs.00.01 and 03.eds
CU 03.00 EDS_PST_Rev4_5. Through the fieldbus possible start and stopthe motor, perform
jog, sequence start, read out currents and frequency, achieve information about protections, warnings, faults and
much more.03.05.abb.eds
CU 03.04
