ABB Softstartéry - komunikace (EN)

| Kategorie: Leták / Datasheet  | Tento dokument chci!

Vydal: ABB s.r.o, ELSYNN Autor: ABB ELSYnn

Strana 124 z 225







Poznámky redaktora
See chapter “Setting and configuration” the installation manual for programming the inputs outputs.02 which can checked the softstarter display Menu STATUS INFORMATION Ver xx. For technical data and descriptions the Modbus fieldbus plug, see document 2CDC194001D0201 available www.xx.com/lowvoltage . Through the fieldbus possible startand stop themotor, perform jog,sequence start, read out currents and frequency, achieve information about protections, warnings, faults and much more. Please check whish the actual softstarter version your case.abb.xx. • Switchingfrom one type control another (fieldbus control hardwire control) • Re-programming the programmable inputs • Reset all Settings (programmable input set Enable) 1SFC132046M0201.02.Modbus The Modbus protocol are fieldbus protocols that provides full control and statusinformation thesoftstarter as well writing parameters.. Before the Modbus fieldbus can taken operation following parameters must set the softstarter: ■ Parameter Fieldbus Ctrl set Yes ■ Parameter Fieldbus Type set other ■ Parameter Fieldbus Addr set free communication address. Note that the set-up varies depending used softstarter version and this document describes the softstarter software version 05. ACaution! The motor may start unexpectedly there start signalpresent when doing any the actions listed below