ABB Softstartéry - komunikace (EN)

| Kategorie: Leták / Datasheet  | Tento dokument chci!

Vydal: ABB s.r.o, ELSYNN Autor: ABB ELSYnn

Strana 114 z 225







Poznámky redaktora
04.00.eds CU 03.02 EDS_PST_Rev4_4.eds CU 03.03.01 EDS_PST_Rev4_0.DeviceNet The DeviceNet protocol fieldbus protocol that provides full controland status information the softstarter as well reading and writing parameters.com/lowvoltage . For technical data and descriptions the DeviceNet fieldbus plug, see document 2CDC193001D0203, available www.abb. • Switchingfrom one type control another (fieldbus control hardwire control) • Re-programming the programmable inputs • Reset all Settings (programmable input set Enable) 1SFC132045M0201.02 EDS_PST_5_0. Through the fieldbus ispossibleto start and stop the motor, perform jog, sequence start, read out currents and frequency, achieve information about protections, warnings, faults and much more.05.02 EDS_PST_4_7.00.02. To the programming the PLC, following EDS files are available: Softstarter CU-version EDS file CU 02.eds CU 05.00 EDS_PST_Rev4_5. See chapter “Setting and configuration” the installation manual for programming the inputs outputs. Before the DeviceNet fieldbus can taken operation following parameters must set the softstarter: ■ Parameter Fieldbus Ctrl set Yes ■ Parameter Fieldbus Type set other ■ Parameter Fieldbus Addr set free communication address.01 and 03.eds ACaution! The motor may start unexpectedly there start signalpresent when doing any the actions listed below.eds CU 04