3 RS485 Switching Value Output
Enable connect equipment with RS485 interface.
7.1 Network (PoE) RJ45 (Non-standard PoE)
Standard RJ45 interface for the connection with PoE switch another network switch.
Connect the lock module (an independent power supply is
necessary for the lock).
Note: Door Station can only connected one card reader management device time. PSE shall comply with IEEE
802.
.3af (PoE) and its output power not less than 15.
2.
The intercom will better protected this way.
Enable connect equipment with RS485 interface.4W and its output voltage not less than 50V.
7. See
attached picture for more details. When connecting inductive load device such a
relay electromagnetic lock, you are recommended use a
diode 1A/400V (included the accessories) anti-parallel
with the load device absorb inductive load voltage peaks.
Warning!
1.0 (04/2026) Page 31
7 DEVICE WIRING
7. Connect the
lock module(independent power supply necessary for the lock). The load current the relay cannot greater than 2A.
The interface can connected one IC/ID card reader used for reading the information built-in card reader.User manual VES-B202/B205
V 1.2 Power Custom input configuration interface Wiegand
The power interface Door Station connects 12V power
