-.2 can assem-
bled adjacently.. More details are available from the manufacturers..
Fused disconnect terminal block
with pivoting fuse holder
Fuse replacement:
When selecting miniature metric fuses, make sure that the
maximum power loss listed below not exceeded.
Individual
argmt.
Miniature fuses 20
Series
Item No.
Fuse terminal blocks
1.5 mm²
“insulated ferrules; mm”
2 250 rated voltage
6 rated impulse voltage
3 pollution degree
“ Please observe the application notes:
Jumpers, from page 150
Marking, from page 230
“ protective warning marker and insulation stop
must applied individually.com
Fuse terminal blocks with width 6.
.com
Rail-Mount Terminal Blocks, TOPJOB® S
Rail-Mount Terminal Blocks, TOPJOB® S
1 Conductor range: 0...
“ Approvals and corresponding ratings,
visit www...75 mm² “s”
and 0..5 W
2.wago.75 2.
Group
argmt.-..
2002-1811/.
2002-1711/.5 W
1. The
power loss determined according IEC 60947-7-
3/VDE 0611-6 23°C.
Fused disconnect terminal block
with pivoting fuse holder
Pivot the fuse holder into the locked open position.83
2002-1611
2002-1711
2002-1811
2002-1611/. Therefore, such
applications, the rated current must reduced neces-
sary. there adjacent fuse terminal block
at the end the assembly, end plate must used.6 1. Due the 6.6 1.
Group
argmt..6 2.2 width
of double-deck terminal blocks with end plates, 2004
Series Push-In Type Jumper Bars must used.
Overload and
short circuit protection
Short circuit
protection only
Individual
argmt......-.5 2.wago.6 2.. Higher ambient temperatures represent an
additional impact miniature fuses.. The temperature rise the termi-
nal blocks must checked according their application
and mounting...5 W
www.25 mm² “s+f-st”
Push-in termination: 0
