“ Approvals and corresponding ratings,
visit www.
Test slots both terminal block sides allow for direct
measurement.
.g., generator
junction boxes).
Test slots both terminal block sides allow for direct
measurement.com
Disconnect/test terminal block with knife disconnect
(2006-8671) disconnect position
Both 2006-8671 and 2006-8661 TOPJOB® Disconnect
Terminal Blocks are specially designed for use photovol-
taic and wind power systems, where voltages exceeding
1,000 (IEC) and 600 (UL) are required (e.5 mm²
“insulated ferrules, mm”
2 1000 VAC/DC rated voltage
1500 VDC
12 rated impulse voltage
3 pollution degree
“ Please observe the application notes:
Marking, from page 230
“ Protective warning markers must applied individ-
ually.
• With terminal block width mm, the maximum
cross-section for solid and fine-stranded conductors
is mm² (AWG and mm² (AWG 10) for ferruled
conductors.
• Equipped with two test slots
• Compatible with through terminal blocks the same
profile and all other TOPJOB® terminal blocks
Carrier terminal block with disconnect plug (2006‑8401) in
operating position
Commoning mm-wide terminal block via push-in type
jumper bars: (2006-433) and (2006-435).wago.
Alternatively, measurement can also performed using
TOPJOB® Connectors (2006-511) from terminal block
1 Spacer modules (2006-549) must used com-
pensate for the terminal block width.
• Ideal for high voltages renewable energy applications
• Disconnect terminal blocks with two alternative dis-
connect options:
with orange knife disconnect (2006-8671)
with orange disconnect plug (2006-8661)
• These 2006 Series terminal blocks are approved for
1,500 VDC (IEC) 1,000 VDC (UL) and A.5 mm² “s+f-st”
Push-in termination: mm² “s”
and 1.com
Rail-Mount Terminal Blocks, TOPJOB® S
Rail-Mount Terminal Blocks, TOPJOB® S
1 Conductor range: 0.97
www.
Carrier terminal block with disconnect plug (2006‑8401) in
parked position
Cover (2006-191) seals unused conductor entry.wago
