Test condition grounding
Slide link open, auxiliary circuit not grounded,
red LED/neon lamp illuminates.5 mm²
“insulated ferrules, mm”
2 800 rated voltage
8 rated impulse voltage
3 pollution degree
“ Please observe the application notes:
Jumpers, from page 149
Marking, from page 230
“ Approvals and corresponding ratings,
visit www.
Blind plug for carrier terminal block (indicates discon-
nection)
Test condition grounding
Slide link open, auxiliary circuit not grounded. This required for starting stopping those
machine functions, which can cause hazardous situation
including: damaging the machine halting work prog-
ress the event unintentional starting failure stop. When this does not help, due other rea-
sons that electronic circuits cannot connected the
protective bonding circuit, other measures must taken
to achieve the same level safety.3.2 and the devices must connected as
described Section 9.
Carrier terminal block (2006‑401) with disconnect plug
(2006‑1661) operating position
IEC 60204/DIN VDE 0113 “Safety machinery Electrical
equipment machines Part General requirements,”
Section 9.4 can prevent unintentional
operation.91
H 1
F 1
K 1
K 2
T 1
LED/Neon lamp
green
LED/Neon lamp
red
H 1
F 1
K 1
K 2
T 1
LED/Neon lamp
green
LED/Neon lamp
red
H 1
F 1
K 1
K 2
T 1
LED/Neon lamp
green
LED/Neon lamp
red
www.wago.1.
In order fulfill this requirement, connection the
protective bonding circuit must provided accordance
with Section 8.com
Ground conductor disconnect terminal block top view
Operating condition
Slide link closed, auxiliary circuit grounded,
green LED/neon lamp illuminates.wago.4.
.
Multipole control switches that interrupt all live conduc-
tors must used where the control circuit directly
connected between the phase conductors the supply
or between phase conductor and neutral conductor,
which either not grounded grounded through high
impedance.4.g.5 mm² “s+f-st”
Push-in termination: mm² “s”
and 1.1., residual current device), which either indicates
a ground fault interrupts the circuit automatically after
a ground fault.com
Rail-Mount Terminal Blocks, TOPJOB® S
Rail-Mount Terminal Blocks, TOPJOB® S
1 Conductor range: 0. Control circuits fed from a
transformer and not connected the protective bonding
circuit must provided with insulation monitoring
device (e.1:
Ground faults control circuits must not cause uninten-
tional starting, hazardous movements, prevent stopping
of the machine.
Carrier terminal block (2006‑401) with disconnect plug
(2002‑1661) parked position
In the case electronic circuits, the connection one
side the control circuit the protective bonding circuit
in accordance with Section 9
