Poznámky redaktora
5 W
1.2 can assem-
bled adjacently.... The temperature rise the termi-
nal blocks must checked according their application
and mounting.wago.5 2. Due the 6.2 width
of double-deck terminal blocks with end plates, 2004
Series Push-In Type Jumper Bars must used.83
2002-1611
2002-1711
2002-1811
2002-1611/...com
Rail-Mount Terminal Blocks, TOPJOB® S
Rail-Mount Terminal Blocks, TOPJOB® S
1 Conductor range: 0.
2002-1711/.
2002-1811/..-.com
Fuse terminal blocks with width 6.
Group
argmt.
.6 1....
Fused disconnect terminal block
with pivoting fuse holder
Pivot the fuse holder into the locked open position..
Group
argmt.5 mm²
“insulated ferrules; mm”
2 250 rated voltage
6 rated impulse voltage
3 pollution degree
“ Please observe the application notes:
Jumpers, from page 150
Marking, from page 230
“ protective warning marker and insulation stop
must applied individually.5 W
www.
“ Approvals and corresponding ratings,
visit www.
Individual
argmt. The
power loss determined according IEC 60947-7-
3/VDE 0611-6 23°C. More details are available from the manufacturers.
Overload and
short circuit protection
Short circuit
protection only
Individual
argmt.
Miniature fuses 20
Series
Item No..wago. Higher ambient temperatures represent an
additional impact miniature fuses.6 2.75 2.6 2.
Fused disconnect terminal block
with pivoting fuse holder
Fuse replacement:
When selecting miniature metric fuses, make sure that the
maximum power loss listed below not exceeded... Therefore, such
applications, the rated current must reduced neces-
sary.....6 1.75 mm² “s”
and 0.-..
Fuse terminal blocks
1. there adjacent fuse terminal block
at the end the assembly, end plate must used.-.5 W
2.25 mm² “s+f-st”
Push-in termination: 0
