Poznámky redaktora
Creating spacer housings for electric motor wiring rail-
mount terminal blocks via
lockout caps (2002‑192) for conductor entry and operat-
ing slot.75 mm² “s”
and 0. Marking clamping points via WMB Multi Marking System.com
Rail-Mount Terminal Blocks, TOPJOB® S
Rail-Mount Terminal Blocks, TOPJOB® S
In addition rail-mount terminal blocks for electric motor wiring, special versions are also available.65
www.wago.5 mm²
“insulated ferrules, mm”
2 800 rated voltage
8 rated impulse voltage
3 pollution degree
3 Terminal blocks with mark are suitable for II
applications.
Testing with voltage tester. This also
prevents wiring errors conductor entry unused.25 mm² “s+f-st”
Push-in termination: 0.wago. When using devices with
protective insulation for example, there are open ground clamping units that could create confusion.
440 A
17 jumper
“ Please observe the application notes:
Jumpers, from page 146
Testing accessories, from page 145
Marking, from page 230
“ Approvals and corresponding ratings,
visit www. Sharing common profile, this terminal block version can put next the appropriate electric motor wiring
terminal block without using intermediate plates.
Group marking via marking strips (Item No.com
.75 2. 709‑177
1 Conductor range: 0. That makes the rail assembly easier understand and wire.
• Version without ground contact and with three potentials:
Clearly designated clamping units are the primary advantage this terminal block design.
• Version without ground contact and only two potentials:
These terminal blocks were custom designed support additional functions, such engine brakes temperature
sensors
