Poznámky redaktora
Furthermore, all
equipotential bonding conductors must connected to
the potential equalization busbar and clearly arranged so
they can disconnected individually and accessed any
time.5 mm²
“insulated ferrules, mm”
2 Conductor range: 0. Depending their function, they must provided
with captive marking., insulation testing possible for every
circuit without disconnecting the N-conductor.
Power distribution disconnect terminal blocks
According DIN VDE 0100-710, “Requirements for
operating facilities, rooms and special installations –
medical facilities,” equipotential bonding conductors shall
be run potential equalization busbar.5 mm² “s+f-st”, mm²
“f-st”;
Push-in termination: 2.5 mm²
“insulated ferrules, mm”
4 250 rated voltage
4 rated impulse voltage
3 pollution degree
“ Approvals and corresponding ratings,
visit www.
.75 mm² “s”
and 0.
Touch-proof N-busbar via inserted separator plate
N-conductor disconnect terminal blocks
For the construction and operation power installations
in fire-prone, hazardous locations public buildings –
such conference centers, stores, hospitals, schools,
theaters hotels the DIN VDE 0100-710 DIN VDE
0100-718 standards shall observed.com
Removing the separator plate from the busbar carrier or
from the N-disconnect terminal block. The potential
equalization busbar and the protective ground conductor
busbar must mounted common housing and be
connected each other using disconnectable copper
conductor minimum mm² AWG).
WAGO N-disconnect terminal blocks meet this require-
ment.5 mm² “s”
and 2. DIN VDE 0100-
482 shall also observed for fire-prone, hazardous
locations.
Inserting separator plate removed from N-disconnect
terminal block.5 mm² “s”
and 1.
Inserting the separator plate into the busbar carrier to
protect the N-busbar against accidental contact. These VDE regulations mandate that every
neutral conductor must provided with disconnection
device so, e.com
Rail-Mount Terminal Blocks, TOPJOB® S
Installation Rail-Mount Terminal Blocks, TOPJOB® S
Installation
Busbar Carrier
1 Conductor range: 0.wago.
WAGO’s power distribution disconnect terminal blocks
meet these requirements.5 mm² “s+f-st”
Push-in termination: 1.75 2.25 mm² “s+f-st”
Push-in termination: 0.g.wago.5 mm²
“insulated ferrules, mm”
3 Conductor range: 0.207
www
