5mm² connections
Load CDAE-01/01
230VAC, 50Hz, 40-500W incandescent lamps or
electronic transformers, trailing-edge,
NO inductive LOADS!!!
Internal overload and short-circuit protection
CDAE-01/02, CDAE-01/03
230VAC, 50Hz, 250W incandescent lamps,
electronic transformers, trailing-edge
230VAC, 50Hz, 40W (typical) “dimmable“
energy-saving lamps LED lamps for reversed
phase control dimming *)
NO inductive LOADS!!!
Internal overload and short-circuit protection
Dim level CDAE-01/02: 20-100%
CDAE-01/03: 0-55%
Pre-protection Power circuit breaker 16A, charateristic C
ATTENTION:
Keep least distance case several devices are used.This explicit-
ly stated the packaging. not place the
device near heat sources (transformers, halogen lamps etc. dimmable power and dimming result may to
a large extent depend the type lamps LEDs used, the manufacturer.EATON SYSTEM
54
Dimming Actuator CDAE-01/01, CDAE-01/02, CDAE-01/03
Technical Specifications
Power supply 230VAC, 50Hz
All connections Single-wired 1.The max. Allow for
sufficient heat draw-off. Check max. -25 +70°C
Colour the frame Grey, RAL7035
Size the frame HxWxD 150 28mm
Length the connection wires 150mm
Approval Printed onto the device
*) general rule, only “dimmable“ energy-saving lamps “dimmable” LED
lamps suitable for reversed phase control dimming can dimmed. not place dimming actuators top each other.), keep distance of
approx.
An insufficient dimming result connection with LED lamps energy-saving
lamps not reason for complaint about the CDAE-01/02 CDAE-01/03 dimming
actuator, will not accepted such and therefore excluded from every type
of warranty.
. 200 mm. operating temperature, reduce power where
necessary (see wiring diagram)
Frequency 868,300 MHz
Type transmission Bi-directional, via coded telegrams
Indoor range Typically 50m, walls ceiling
(depending wall thickness and material !!)
Degree protection IP20
Degree soiling 2
Operating temperature +45°C
Storage /transportation temp
