operating temperature, reduce
power where necessary.5mm2 all connections
Load 250W 250VA)
LED, ESL: 100W (depending the lamp type)
ATTENTION: Please note the dimmer use trailing edge mode for incandescent
lamps automatically. Check max. case the dimmer forced control incandescent lamps in
leading edge mode the output reduction factor about 50%.5 (>0.
Storage /transportation temp.
Power standby (typical)
CDAU-01/04(-I) 325mW
CDAU-01/04-E 425mW
Energy Measurement Sensor (-E) 0.), keep a
distance approx.
R
ESM
. 200 mm. not place dimming actuators top each other. -25 +70°C
Colour the frame Grey, RAL7035
Size the frame HxWxD 49. Do
not place the device near heat sources (transformers, halogen lamps etc.01 higher
If one the connected devices does not support the Extended Status Messaging
format the Actuator will switch back the standard status messaging format.5 18mm
Length connection wires 150mm
Approval Printed onto the device
Basic Mode support:
Local Input mode: Push-button (Mode 1), Switch (Mode 2), Mixed
(Mode 3), Rocker (Mode 4), Sensor (Mode 5)
DIM Profiles: R/L/C Standard, LED LED LED CFL/ESL,
ON/OFF (Switching)
Extended Status Messaging support:
ATTENTION! Extended Status Messaging supported the following Smart
Devices:
Room Manager V41c higher
Smart Home Controller V2.10 higher
Ethernet V2.5 250 ±0.1 higher
USB RF-Communication stick V2.5 W)
Measurement units Energy kWh, Active power W
Binary Input voltage Maximum 265V
Input contact resistance <10kΩ reliably ON, >50kΩ reliably OFF
Voltage difference <1V reliably ON, >3V reliably OFF
Internal protection Overload, overvoltage, temperature,
auto recovery (load will disconnected)
Pre-protection Power circuit breaker 16A, characteristic C
Frequency 868,300 MHz
Type transmission Bi-directional, via coded telegrams
Indoor range Typically 50m, walls ceiling
(depending wall thickness and material !!)
Function Assignments 32
Routing Paths 32
Degree protection IP20
Degree soiling 2
Operating temperature +55°C
ATTENTION: Keep least distance case several devices are used.EATON SYSTEM
33
Smart Dimming Actuator CDAU-01/04, CDAU-01/04-I, CDAU-01/04-E
49,5
52,6
18
Technical Specifications
Power supply 230 VAC +10% -15%, 50Hz
Connections Single-wired 1.5 45.
Allow for sufficient heat draw-off
