• Burrs and unevenness must removed!
Information:
Um das Gerät gemäß UL/CSA/IEC-Standard installieren, müssen die folgenden Hinweise
beachtet werden.
Caution!
The pinout the power supply interface must observed!
The power cable must implemented with wire cross section 1.23
.
• For wall thicknesses mm, may not possible achieve IP67 protection.9
Secure the conductors with wire end sleeves in
the terminal contacts shown the figure be-
low and tighten the screw clamp terminals with
a screwdriver (max.3. Close the terminal contact removing the
screwdriver.
• Wenn das Gerät nicht bestimmungsgemäß verwendet wird, kann die Schutzwirkung
des Geräts beeinträchtigt sein.
(2)
(3) (4)
24 VDC
0 VDC
(1)
74 Smart Camera Smart Sensor User's manual 1.
Installing screw clamp terminal block 0TB103.91
Insert screwdriver into the cage clamp terminals
② and secure the conductors with wire end sleeves
① the terminal contacts shown the figure
below.
Notice!
Primary circuits from which the connected secondary voltages are generated must lim-
ited overvoltage category and are permitted have maximum system voltage of
300 V. tightening torque 0.4 Nm).Machine vision accessories
Notice!
Failure achieve the degree protection can result damage the module!
• IP67 protection the M12 integral connector only achieved with correctly con-
nected and locked male connector pair. is
important pay attention the label the screw
clamp terminal ②.
The power supply must protected with (slow-blow) fuse.5 mm2 and wire end ferrules (copper
wires only, aluminum wires!).
Minimum temperature range the cables connected the field wiring terminals: 80°C.3.1.
(2)
(1)
+
-
(4)
(3)
24 VDC
0 VDC
Installing cage clamp terminal block 0TB103. important pay attention the
label the cage clamp terminal ④.2 Wiring
Only use the available accessories for wiring (see "Order data" page 70).
• The specified dimensions and tolerances the opening must strictly observed.
10
