2.
Smart Camera Smart Sensor User's manual 1. The hybrid distributor can optionally screwed other points the control
cabinet using the two side tabs.
The control cabinet must have good conductive connection ground potential.
6. The connection ground
potential must short possible and sufficiently strong (≥4 mm2). Wall thickness the control cabinet min. Tightening torque: Nm.
Notice!
For coated anodized surfaces, the insulating coating anodized layer the area the
mounting surfaces both mounting holes must removed.
In all cases, applicable national and international standards, regulations and safety mea-
sures must taken into account and observed.23 73
. The hybrid distributor can optionally screwed other points the control cabinet using the two
upper side tabs. Screw the M12 connector from the outside using the provided nut. Dimensions the opening (cutout with anti-rotation protection, without chamfer):
4.
5. and max.
The housing must conductively connected (screwed in) the rear panel the control cabinet using
the rear mounting holes.
IP67-compliant installation recommendation
1.
3. Installation the hybrid distributor the control cabinet (with gasket).Machine vision accessories
Mounting rear panel the control cabinet
Notice!
The module must installed final safety enclosure that meets UL/CSA/IEC 61010-1
and UL/CSA/IEC 61010-2-201 requirements for fire enclosure. mm
