Example: Setting Address 20
Turn the following switches:
- Bit (decimal value 4).
Each switch corresponds specific binary weight (decimal value) shown below:
Bit No.HW-group.
- All other switches must remain OFF.
Calculating the Address
The final device address calculated summing the decimal values all DIP switches
set the position. 6
Decimal value 32
To set the desired address, add together the values the switches set ON.com 18
Baud Rate Configuration
The baud rate determined the positions DIP switches and SW1. 6-bit
value (0-63).
- Bit (decimal value 16).
- Bit 8.
If both switches are OFF (0), the baud rate taken from the software configuration.
Device Address Configuration
The address determined the positions DIP switches SW1.
If the address the address taken from the configuration, which intended for
use with HWg Perseus.
Otherwise, the baud rate set according the following table:
Baud Rate 4800 9600 19200
DIP Switch 1
DIP Switch 1
Example: Setting Baud rate 19200
Turn the following switches:
- Bit 7.
Calculation: (Bit 16(Bit 20
