New PCB rev I
or later.
6. Mount the front cover. Disconnect the voltage from terminals 1L1
3L2 and 5L3 (main supply). Mount the new PCB. Cut the old wires, and exchange the
terminals for the gate wires, fan wires, and
thermal switch the new ones included in
the package.
7.Start here if
Replacing older PCB marked Rev older (for 690V Rev older).
These PCB have tabs (see Fig connectors for the gate wires and other internal connections. Discharge the package with the new PCB
by moving earth. Then all the
internal cable connectors have converted fit the new PCB.
11.
Make also sure that you have connect the cable from the thyristors
correct DS
Ready for start!!
-. Remove the front cover.
Step step. The needed connectors are enclosed
in the new PCB package. Discharge the tools and yourself by
touching earth (if you are not earthed). Disconnect all cables from the terminals 1
3.
2.
1.
10. Connect the voltage and the other cable.
PS make sure that you are placing the jumper for supply voltage the
correct position, 110 120V 220 240V.
12. Please note that the gate wires are connected differently the new PCB.
4. Mount the cable the PCB from the
thyristors, fans and thermal switch.
9.
This chapter valid replacing the broken PCB with the newest revision (rev later) PCB. Remove the old PCB. Please note that the gate wires
have new connection position -
See colour marking Fig. 4.
5.
8.
Mount also the connector for Supply
Voltage. Disconnect the cable the PCB from the
thyristors, fans and thermal switch.
Fig
