The
connection ground potential must short possible and sufficiently strong (≥4 mm2).3.) must be
in full contact with the mounting surface for mounting and heat dissipation! Attaching uneven surfaces
can result reduced heat dissipation from machine vision modules.Commissioning
8.
• Observe the bend radius when connecting cables.
The mounting points specified the dimensional drawing (see "Dimensional drawing" page 19.
• Install the device flat, clean and burr-free surface. Products must protected against impermissible dirt and
contaminants. aluminum, steel sheet cast iron) using the mounting points.5 mm.1 Installation
Important information about installation
• Observe climatic ambient conditions.
At the back, the Smart Camera module must screwed onto material that conducts heat and electricity
well (e.3 Installation and wiring
Notice!
Possible damage the device due improper handling!
■ Carry out maintenance work only voltage-free state.
8.g.
The mounting surface the machine must have good conductive connection ground potential. The maximum operating temperature and
degree protection specified the technical data must observed during installation (see "Technical
data" page 9).
In addition, essential provide adequate spacing for air circulation above and below machine vision
modules ensure sufficient heat dissipation.
For installation, the use the mounting accessories that can ordered strongly recommended, see
"Installation accessories" page 79.
Notice!
For coated anodized surfaces, remove the insulating coating anodized layer the
area the mounting surfaces.23
.
48 Smart Camera Smart Sensor User's manual 1.
■ Make sure that all modules and components are handled carefully.
It important ensure that machine vision modules are mounted sufficiently strong, thermally con-
ductive, flat surface the machine that free contaminants. The
thread length the screw engaging the camera body not permitted exceed 7.
Notice!
If the mounting screws are too long, there risk damage the camera body
