Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
118 inch: ±0.039inch less than .039inch:
Min.2 ±.3 ±. .012
PC board pattern (Bottom view)
3x1.012
PC board pattern (Bottom view)
-6 -
6x1.008
Min.039inch less than . .197 .004
Schematic (Bottom view)
COIL
NC i
NO
COM
COM
The lamp control type has polarized contacts.012
PC board pattern (Bottom view)
A------
5x1.063 dia.197 .039inch: ±0.004
Schematic (Bottom view)
COIL
; >COM
NO
'L
COM
The lamp control type has polarized contacts.276 .
Connect COM the (plus)” side.039inch less than . 1mm .2 ±.118 inch: ±0. Intervals between terminals measured surface level.063 dia
e -
10.1 ±.1 ±.
5x.
Dimensions (thickness and width) terminal measured before pre-soldering.378
.
3x.004
Min.
90 61282 tc: 310113D
COIL
COIL
COIL
.2 ±.6
.(ACTC)
Double make contact Form type/2 coil latching type
External dimensions
Dim ension: Tolerance
Less than 1mm . Intervals between terminals measured surface level.118 inch: ±0.004
Min.118 inch: ±0.
Schematic (Bottom view)
COIL
n r
NO c
COM
COM
The lamp control type has polarized contacts.3 ±.
1 Form C/Standard type
Pin Paste type External dimensions
Tolerance
±0.118 inch: ±0.378
.
Connect COM the (plus)” side.039inch: ±0.
e -
10.1 dia. 1mm . .008
Min.
Dimensions (thickness and width) terminal measured before pre-soldering.
Connect COM the (plus)” side.1 ±.8
7 9.8
d 9.118 inch: ±0.
* Dimensions (thickness and width) terminal measured before pre-soldering.3 ±.6 dia.Q43 dia. Intervals between terminals measured surface level.276 .1 ±.008
Min.6 dia.
6x.004
Dim ension:
Less than 1mm .6
. 1mm .1 ±.425
Tolerance: ±0.
1 Form A/Standard type
Pin Paste type External dimensions
Dim ension: Tolerance
Less than 1mm .425
Tolerance: ±0
