Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
1 ±.197 .2 ±.2 ±. .
ds 61282 tc: 310113D 89
COIL
5
COIL
COIL
Automotive
.039inch: ±0. 1mm . 1mm .012
PC board pattern (Bottom view)
6x1.6
.276
9.378
.1 ±.1 ±.3 ±.
Connect COM the (plus)” side.118 inch: ±0.6 dia.(ACTC)
DIMENSIONS (mm )
1 Form type/Standard type External dimensions
Dim ension: Tolerance
Less than 1mm .004
Min.3 ±.
6x. .425
Tolerance: ±0.012
PC board pattern (Bottom view)
6x1.2 ±.063 dia.063 dia 10.118 inch: ±0.
Dimensions (thickness and width) terminal measured before pre-soldering.039inch less than .118 inch: ±0.004
Min.
6x.
1 Form C/Standard type
External dimensions
Dim ension: Tolerance
Less than 1mm .1 ±.004
Min.039inch: ±0.1 ±.118 inch: ±0.004
Schematic (Bottom view)
COIL
NC <
NO
COM
COM
* The lamp control type has polarized contacts
Connect COM the (plus)” side. 10.378
. 1mm .425
Tolerance: ±0.004
Schematic (Bottom view)
_ ________
" COM
COM
* The lamp control type has polarized contacts.008
Min. Intervals between terminals measured surface level.004
Schematic (Bottom view)
COIL
NO
NO
COM
COM
The lamp control type has polarized contacts.
Connect COM the (plus)” side.008
Min. Intervals between terminals measured surface level.1 ±.3 ±.039inch less than . .6 dia. Intervals between terminals measured surface level.008
Min.118 inch: ±0.
Double make contact Form type/Standard type
External dimensions
Dim ension: Tolerance
Less than 1mm .118 inch: ±0.012
PC board pattern (Bottom view)
Tolerance: ±0.039inch: ±0.039inch less than .6
.
* Dimensions (thickness and width) terminal measured before pre-soldering.8
7
.197 .8
\
- -
9.
* Dimensions (thickness and width) terminal measured before pre-soldering