<output> replaced the output number (1)
. possible
to use the noop command keep the connection alive for the next seconds.41
Start Telnet connection NETIO device address and its Telnet port
When the connection established, the NETIO device returns the following response and ready to
receive commands.g. parameters
are provided, then returns states all
outputs.1
Note: The Telnet connection automatically terminated after seconds inactivity. port list 10x1 invalid).
No-operation
port list [xxxx] Control/monitor all outputs based the
parameters xxxx (described below) for each
output. All parameters must have valid value
otherwise the command will not accepted
(e.
Control all outputs and ON, and OFF):
port list 1001
250 OK
Returns state output:
port list
250 1001
(outputs and are ON, and OFF)
port <output> <action> Control the output.
noop Keep the Telnet connection alive for the next
60 seconds.
Replace <username> and <password> the
equvalent attributes defined the Telnet
protocol configuration (Figure 28)
<password>
Example log with username netio and
password netio:
login netio netio
quit Log out and terminate Telnet connection.
Telnet welcome message
100 HELLO 489F6C4F KSHELL V2.
Command set
Command Description
login <username>
<password>
Log user.
Outputs are numbered from the left right
(1-2-3-4)
