Weight
approx.6, IEC 60228 cl.
Ⴠ During the packeting performance, must started with the smaller cross-section which lays the bedding surface and will builded successively
so that the biggest cross-section laying the top.
weight
kg km
Outer
dimension
approx. mm
No. bending flexibility can achieved plane surface.
mm²
Part no. For this
purpose, the corresponding fitting instructions should followed.6
Ⴠ Ⴠ
Special-Neoprene-flat cable, screened,
adapted DIN VDE 0250 part 809
Outer sheath cold resistant
Ⴠ Extensively oil resistant
Ⴠ Temperature range
flexing -30°C bis +80°C
fixed installation -40°C +80°C
Ⴠ Extremely small bending radius
Ⴠ Core insulation special rubber High flexibility
Ⴠ Core identification DIN VDE 0293
- cores coloured
- from cores, black with continuous
white numbering
Ⴠ Minimum waste space
Ⴠ Nominal voltage U0/U 300/500 Packeting possibility
Ⴠ Test voltage 3000 The high degree screening density assures
disturbance-free transmission all signal and
impulses
Ⴠ Minimum bending radius
15x cable thickness GN-YE conductor
Ⴠ Cores screened individually
Ⴠ Radiation resistance
up 50x106 cJ/kg (up Mrad)
Ⴠ Outdoor application
Ⴠ Cores laying parallel Tests
Ⴠ Copper screened braiding,
approx.cores x
cross-sec.cores x
cross-sec.
kg km
Cop.
= The product conformed with the Low-Voltage Directive 2006/95/EC. (RJ01)
Flat and Ribbon Cables
279
J
Suitable accessories can found Chapter X.
EMC Electromagnetic compatibillity
To optimize the EMC features recommend large round contact the copper braiding both ends.
mm²
Part no.
Weight
approx. These cables are
also available for export with UL-approval request. AWG-No.
AWG-No. The actual cross-section mm².
weight
kg km
Outer
dimension
approx.
• Cable Gland STK-F
• Cable Gland STS-F
.
kg km
Cop.
Installation notes
Cables reels with flat cables must transported standing position the flange.NEO-Flat-C(MCHÖU) screened, EMC-preferred type
Properties
Cable structure
Technical data
Ⴠ Copper-conductor bare tinned to
DIN VDE 0295 cl.
Ⴠ case multicore flat cables with small cross-section, smaller than 2,5 mm², very critical due its low tensile stress. mm
No. such case, you should
add 10% reserve wire for calculation.6, extra fine-wire,
BS 6360 cl.
Ⴠ Further, careful symmetrical load distribution. 85% coverage
Ⴠ Behaviour fire
to DIN VDE 0482-332-1-2
DIN 60332-2-1, IEC 60332-1 (equivalent
DIN VDE 0472 part 804 test method B)
Ⴠ Outer sheath special Neoprene
Ⴠ Outer sheath coulor black (RAL 9005)
Note
Ⴠ with green-yellow conductor
Ⴠ AWG sizes are approximate equivalent
values.
Application
Neoprene screened flat cables are used mainly trailing cable for crane installations, floor conveyer systems and shelf control units.
Ⴠ Put the cable trolly the guiding rail upon carrier beam and push them together the starting point. The distance between the bedding surface
of two cable trollys must wider than the double thickness cable-packet.
16
520,0
231,0
7,9 42,0
8 1,5
28100 14
540,0
247,0
8,5 34,5
6 2,5
28103
14
1000,0
494,0
8,9 68,0
12 2,5
28104
16
790,0
346,0
7,9 61,0
12 1,5
28101
4
1650,0
1116,0
16,0 51,0
4 25
28302
14
420,0
164,0
8,5 25,5
4 2,5
28102
Dimensions and specifications may changed without prior notice
