Poznámky redaktora
)
Can swivelled beyond 360° for
directional lighting with unlimited rotation
Can controlled standard electronic switch
with neutral sensor with neutral
Consumption 2.2 W
Luminous flux 110 lumens Lifespan 50,000 hours
Selection chart for mechanisms and cover plates XX
Selection chart for plates p.Nos Low-level and emergency lighting
Signalling light
1 CM0276 Power supply 230 VA
2 adjustable light levels
Maintenance-free bulb (LED)
Supplied with colours (orange, blue,
green, red), label holder and set of
10 pictograms for identification
Supplied with cover plate, fitted with mounting
support and plate
Self-contained low-level light
1 CM0281 Power supply 230 V
Round light with blue LED standby mode
Turns automatically the event a
power failure (white LED)
Working reserve max.3 W
Luminous flux 110 lumen (equivalent W
incandescent)
Lifespan 40,000 hours
Supplied with cover plate, fitted with mounting
support and plate
For installation flush-mounting box depth mm
min.
Possible install maximum sensors in
parallel the same circuit.Nos Active power compensator
1 401
To installed close the source possible
Makes 2-wire electronic lighting controls without
neutral compatible with all commercially available
loads (LED, CFL, ELV halogen with ferromagnetic or
electronic ballast, fluorescent tube)
Consumption: 0.8 W
Luminous flux lumens Lifespan 50,000 hours
Supplied with matt chrome cover plate, fitted
with mounting support and plate
For mounting depth box
Spotlight for low-level lighting
1 CM0272 For installation skirting board, a
wall hallway corridor etc.
Supplied with opalescent cover plate and Titanium
ring, fitted with mounting support and plate
Low-level lighting sensor
1 CM0278 Used illuminate pathway shed light
on obstacle change level help
find one's bearings the dark without
turning the main light
Equipped with infrared detection cell and LED
beam
To used with cover plate, mounting support and
plate
Detection angle: 180°
Range: m
CN0270 Black Onyx Glass plate
CélianeTM
wall-mounted sensors
CélianeTM
task, signalling, low-level and emergency lighting
CM0051 cover plate
+ Cobalt Blue plate
Red catalogue numbers: New products
Red catalogue numbers: New products
.2 (standby) and 1.01 W
To used with cover plate, mounting support and
plate
3-wire with neutral
1 CM0051 Power supported each bulb type:
- LEDs, CFLs: 500 LED
- Halogen, incandescent: 2000 max.4 W
Luminous flux 120 lumens Lifespan 50,000 hours
Supplied with white plastic opalescent cover plate,
to fitted with mounting support and plate
Spotlight for staircase
1 CM0274 Used create directional, decorative
lighting
Recommended installation: off the
floor
To used with cover plate, mounting support and
plate
For installation flush-mounting box depth mm
min. Master/Slave option,
10 slaves max.
Can controlled standard or
electronic switch with neutral a
sensor with neutral
Consumption 2.
- LEDs, CFLs, halogen, fluorescent tubes
with ferromagnetic electronic ballast:
1000 max. Detection range: max.
Can controlled standard electronic switch
with neutral sensor with neutral
Consumption 2. for master
Standby consumption 0.Nos Task lighting
Equipped with maintenance-free LEDs
LED colour: 3000 neutral white
Power supply 230 Energy class A
Screw terminals
LED reading light
Equipped with flexible neck the head can swivel
Built-in ON/OFF switch with dimming option by
pressing and holding
Consumption 3.67
Pack Cat.Nos Motion sensors
Compatible with all commercially available bulbs
Infrared detection
Detection angle: 170°.
Time delay setting: min
Light level threshold setting: lux 1275 lux
Sensitivity setting: levels
Manual lighting control possible via push-buttons
(10 maximum)
With without manual override depending the
choice cover plate
Can installed flush-mounting box, minimum
depth 30mm
2-wire without neutral
1 CM0050 Power supported each bulb type:
- LEDs, CFLs: 100 LED
- Halogen, incandescent: 150 W
- LEDs, CFLs, halogen, fluorescent tubes
with ferromagnetic electronic ballast:
2 150 VA
If several sensors are installed the same circuit,
the minimum load increases (see technical data
sheet)
Possible install maximum sensors parallel
on the same circuit
Can used with DIN rail mounted electronic timer
Standby consumption 0.015 W
To used with cover plate, mounting support and
plate
Pack Cat.8 (operation)
Selection chart for mechanisms and cover plates XX
Selection chart for plates XX
CM0050 cover plate
+ Felt plate
Pack Cat.
1 CB0270 White
(Aluminium head and neck)
1 CN0270 Black
(Aluminium head and neck)
1 CT0270 Titanium
(Aluminium head and neck)
Directional spotlight
1 CM0271 For installation over desk work area
(kitchen, bedroom etc.XX XX
CM0278 Storm Blue plate
Pack Cat
